How to Make an Easy Peasy Envelope Cushion Cover

One of the many wonderful things about living in East London is the range of markets. Ridley Road Market in Dalston is a brilliant place to find lots of unusual and relatively cheap fabrics and has loads of great African tribal prints, which also happen to be bang on trend at the moment.

My friend Amber asked me to make a cushion for her, so I thought I'd take the opportunity to share a tutorial as it really is very easy. It's perfect for beginners and can also be sewn by hand if you don't have a machine.

You will need:

• Cushion filler - I used one that is 44cm x 44cm (you can buy these new or upcycle an old one)
• About 1 metre of material - I used 1.05m of material with a 0.5m width  (the amount will depend on the size of your cushion filler)
• Measuring tape
• Pins & chalk 
• Fabric scissors
• Cotton thread
• Sewing machine (or needles if sewing by hand)

1. Measure your cushion filler, the one I used was 44cm  x 44cm.

2. Now for your fabric; if it's wide enough you can cut out one big piece so that you have less sewing! Add on a few centremetres as a seam allowance - I've added 2 cm. Measure out your material, mark the length you require with chalk on the wrong side of the fabric and cut it out - the fabric I used was 46cm wide and 105cm long. 

As you will see in the diagram below the two sections that you will fold over to form the envelope need to total more than the length of your cushion filler so that the material overlaps. 

(If you are working out your own measurements, you don't need to worry about being too exact but a good guide is to take the length of your cushion filler then add on about a 1/4 of that length again then divide that total between the two sides of the envelope. Don't divide it equally but make one side longer than the other as this will look neater.)

3. Iron your material so that it is all flat 

4. Fold over the ends by 1 cm each end, pin into place and then hem them on the machine (or by hand).

5. Lay the material right side up and put the cushion filler in the middle. Fold over the ends so that they overlap. Make sure it is quite tight around the cushion so that it isn't all saggy when it is finished. Use pins to mark where the folds are on the material.

6. Take the cushion filler out and then pin all around the edges.

7. Sew up the two sides and cut away any excess if necessary.

8. Turn the pillow the right way out and insert the cushion filler. And you're done.

9. Place on a chair and put the kettle on : )